Accès ouvert · CC BY

Forming kinematics analysis of countersinking process

Article scientifique 2017 Sciences de l'ingénieur et technologies Anglais

Résumé

This paper deals with the countersinking process which permits to modify the entrance of an existing drilled hole and to obtain the screw hole countersink. Nevertheless forming kinematics during countersinking process was studied as a function of blank-holding conditions. The effect of blank-holding on the countersinking process was investigated using numerical and experimental analysis. An axisymmetric elasto-plastic finite element model was developed. Four geometrical changes were identified in the workpiece shape: the raise of the outer edge, the retraction of hole diameter, the axial expansion of the sheet near the obtained countersink and the radial expansion of workpiece. Finally, a recapitulative table was found to give a range of each parameter at different blank-holding conditionsDOI: http://dx.doi.org/10.5755/j01.mech.23.3.14071

Citer ce document

Jallouli, I., Mosbah, H., & Krichen, A. (2017). Forming kinematics analysis of countersinking process. Mechanika. https://doi.org/10.5755/j01.mech.23.3.14071

Exporter : BibTeX · RIS (Zotero, Mendeley, EndNote)

Accès au document

Texte intégral archivé sur SPHAERO, en accès ouvert : lisible gratuitement en ligne après connexion. Le document reste aussi disponible à sa source. Se connecter

Voir l'article sur le site de la revue

Licence et provenance

Licence : CC BY

Notice moissonnée depuis OpenAlex le 27/08/2026. Le document reste hébergé par sa source.
Voir le document à la source →

Statistiques

Consultations (hors robots) : 10

Téléchargements (hors robots) : 0

Méthode de comptage