Accès ouvert · CC BY

Design of a single inductor bidirectional DC converter for V2V energy transfer: On board charger architecture

Article scientifique 2026 Sciences de l'ingénieur et technologies Anglais

Résumé

This paper presents a Single-Inductor Bidirectional Converter (SIBC) for unified onboard Electric Vehicle (EV) charging, integrating grid, battery, and wireless ports within a single power stage. The topology enables native Grid-to-Vehicle (G2V), Wireless-to-Vehicle (W2V), and Vehicle-to-Wireless (V2W) operation without hardware reconfiguration, eliminating cascaded converter-inverter structures. Non-ideal steady-state and small-signal models are developed, revealing mode-dependent dynamics including a right-half-plane zero in V2W mode that constrains bandwidth. A two-loop Average Current-Mode Control (ACMC) is proposed to mitigate this limitation, achieving 40× bandwidth improvement over conventional voltage-mode control. Parametric sensitivity analysis of inductor equivalent series resistance establishes quantitative design boundaries for sustaining conversion efficiency above 90%. Scalability assessment to 3 kW operation demonstrates compatibility with silicon carbide devices and a bridgeless totem-pole PFC front-end achieving THD less than 4% and power factor higher than 0.99, satisfying IEC 61000-3-2 Class A with higher than 35 dB ripple rejection at the battery terminals. Experimental validation using a 136 W prototype achieves 93.4% transmitter and 95.07% receiver DC-DC efficiency, with an overall end-to-end efficiency of 75.03% including an 84.5% wireless link. A 1 kW interim hardware test confirms scalable operation, while simulation validates CC-CV battery charging compatibility. The results demonstrate that the SIBC architecture is not the dominant source of system losses and provides a compact, scalable foundation for advanced bidirectional EV charging systems.

Citer ce document

Mostafa, H. H., Ibrahim, A. M., Amer, F. Z., & Sawires, E. F. (2026). Design of a single inductor bidirectional DC converter for V2V energy transfer: On board charger architecture. Scientific Reports. https://doi.org/10.1038/s41598-026-57506-1

Exporter : BibTeX · RIS (Zotero, Mendeley, EndNote)

Accès au document

Texte intégral archivé sur SPHAERO, en accès ouvert : lisible gratuitement en ligne après connexion. Le document reste aussi disponible à sa source. Se connecter

Voir l'article sur le site de la revue

Licence et provenance

Licence : CC BY

Notice moissonnée depuis OpenAlex le 01/10/2026. Le document reste hébergé par sa source.
Voir le document à la source →

Statistiques

Consultations (hors robots) : 9

Téléchargements (hors robots) : 0

Méthode de comptage