Accès ouvert · CC BY

A concurrent bioceramic colloid design for dental crowns additive manufacturing by vat photopolymerization

Article scientifique 2025 Sciences de l'ingénieur et technologies › Technologies émergentes › Fabrication additive (OCDE 2.11) Anglais

Résumé

The subtractive manufacturing of bioceramic dental crowns is standard in the dental sector. Still, it is accompanied by many demerits such as raw material waste, tool wear, high cost, and difficulty in handling complex geometry. Researchers direct their efforts toward additive manufacturing due to its capability to produce products with complex geometry and low material waste. This research aims to develop a concurrent engineering approach based on waste minimization of bioceramic powder extracted from subtractive manufacturing and reuse it as a raw material mixed with a polymer resin and a dispersing agent under an indirect mixing strategy to form a hybrid ceramic colloid for bioceramic additive manufacturing. Our approach consists of six stages: raw powder characterization in which particle size, material compositions, crystalline structure, and unit cell dimensions are determined; ceramic colloid design in which ceramic colloid performance based on layer thickness, ceramic powder vol% is optimized using fuzzy-entropy and fuzzy-topsis methods; indirect mixing strategy; 3d printing of the sample; green part characterization, and manufacturing cost estimation. The characterized powder has an average particle size of 91 nm, the majority of its crystalline structure is in the tetragonal phase with unit cell dimensions in angstrom of 'a' that is equal to 3.59 and 'c' that is equal to 5.16, the optimum bioceramic colloid is achieved at 1% wt of ceramic powder and a layer thickness of 25 microns with an average stability of 30.2 mv. The ceramic colloid is fed into a 3d printer, and the ceramic part is additively manufactured with good homogeneity and much lower cost than subtractive manufactured dental crowns. The ceramic-colloid stability, homogeneity, and layer thickness control are good indicators of the success or failure of the additively manufactured parts.

Citer ce document

Osama, A., Fouda, N., & Eraky, M. T. (2025). A concurrent bioceramic colloid design for dental crowns additive manufacturing by vat photopolymerization. Scientific Reports. https://doi.org/10.1038/s41598-025-24100-w

Exporter : BibTeX · RIS (Zotero, Mendeley, EndNote)

Accès au document

Texte intégral archivé sur SPHAERO, en accès ouvert : lisible gratuitement en ligne après connexion. Le document reste aussi disponible à sa source. Se connecter

Voir l'article sur le site de la revue

Licence et provenance

Licence : CC BY

Notice moissonnée depuis OpenAlex le 29/09/2026. Le document reste hébergé par sa source.
Voir le document à la source →

Statistiques

Consultations (hors robots) : 20

Téléchargements (hors robots) : 0

Méthode de comptage